Results 1 to 10 of 48
Thread: I need two tiny gears
Threaded View
-
05-07-2016, 07:02 AM #24
bear in mind you can always stick a little glue on the shaft and let it dry to give a tighter fit.
the larger gear - a whole 10mm !
That's huge :-)
I can try for a 0.5mm hole - I suspect it'll just make it easier to see where to drill.
how about this:
Dunno if the gaps between teeth would be wide enough, could always drop it down to 9 teeth.
These are all made with the gear script I posted - so you could always mess about with it yourself :-)
The two mesh quite well.
The little one might need a wee tweak to give it longer teeth/arms.Last edited by curious aardvark; 05-07-2016 at 08:05 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help