After a few test cubes I am pretty happy with it.
Did a test print of the 3D Benchy though there are a few issues with it that you all may be able to guide me to fix.
Mainly top layers seem too thin (see picture).
IMG_2562.jpg
Settings are as follows.
Printed setting in Simplify3D
High quality
PLA
Extruder layer 1 at 230 degress
layer 2 at 240 degrees
No heated bed
Capture.jpg
Capture2.jpg
Any advice on how to improve this would be greatly appreciated
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion