awanegenebayo,

I have struggled with this EXACT problem for a year. What causes this, as far as I can tell, is very aggressive overhangs. It happens to me on every overhang where a significant portion of the flesh filament (PLA) is extruded over the air and it has very little to bond to. I tried everything, including cooling to no avail. I was finally able to overcome most (but not all) of the issue by significantly increasing my extrusion temperature. I was printing at 193 and had terrible overhangs just like yours. After a few experiments I found that 210 and even 215 work much better. I tried to go higher (220) but started experiencing jams.

What temps are you printing at? Please try bumping up your temp and let me know how it works for you!!