Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
04-26-2016, 09:07 AM #10
To remove the blue pad I heated the build plate up to 90c and then used heat resistant gloves to peel the pad off after using a scrape tool to raise the corner. After removing it (~30 seconds of light peeling) I used Goof-Off and in 15 minutes I was able to remove all the sticky gunk with a paper towel. After I removed the blue pad I let it cool down as 90c was hot enough to vaporize the Goof-Off when I dripped it onto the aluminum. I believe Goof-Off will stain plastic, so be careful.
Last edited by cncartist; 04-26-2016 at 09:21 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion