Results 1 to 10 of 10
Thread: Need Print Bed Materials?
Threaded View
-
04-22-2016, 09:17 PM #8
I will do, thanks. If you are going to cut it I'll get it at 5.5", I would only need one or two samples.
thanks for your help.
p.s I know a silly question, but you guys wouldn't possibly be able to do round cuts could you? I also use 4 x delta machines, varying from 150mm to 180mm diameter, and I use a few pieces of tape and cut around the edge, it would be so nice to just use one big round cut of tape, but this is not something that's easy to find, there would be a fair bit of wastage cutting circles out of a length I imagine.Hex3D - 3D Printing and Design http://www.hex3d.com
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help