Results 1 to 3 of 3
Threaded View
-
03-07-2014, 12:08 AM #3
I've been trying to print an object that is about 1cm wide, 4.5cm tall and about 12cm long. Every time I printed one corner would lift and shrink about 5mm. I decided to try printing on ABS slurry and it worked perfectly. All the corners stayed down. This was just my first use of the adhesion technique but so far I'm a fan. I had been using Aquanet.
Bambu P1S/AMS
NVision4D http://nvision4d.com
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion