Originally Posted by
printbus
Yeah, a lot of people have said the MakerFarm spool holder has been at least a major contributor. I didn't mention having issues with it because I never used it, or didn't use it longer than I had to.
FYI - someone suggested one of the unused wood parts shown in post #93 is an alternate spool mount, but it still relies on the poor design of having the spool bounce along over a fixed wood edge. Not sure where you'd mount that on a Pegasus without loosing a lot of print volume. Perhaps on the rear side somehow.
Moderator RobH2 used to jump in and discourage people from mounting a spool high up on a printer, arguing that any momentum it picks up as the printer frame vibrates or wobbles can exasperate print quality issues. Just sharing what others have said before.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion