Results 1 to 10 of 36
Threaded View
-
04-13-2016, 06:14 AM #29
- Join Date
- Nov 2015
- Location
- Oklahoma
- Posts
- 22
I suspect the most likely problem will be how to attach a magnet to the motor shaft. The photos don't give me much hope at the commutator end of the motor, unless the magnet were very small and could be glued to the end of the shaft with a droplet of epoxy. I'll have to open it up to see if the gear train provides a better magnet mounting opportunity. Maybe the gear on the output shaft will have a suitable spot. It will be a few weeks before the pump arrives here from China, so I won't know until early May.
Last edited by DoulosDS; 04-28-2016 at 08:53 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion