Results 1 to 9 of 9
Threaded View
-
03-06-2014, 01:56 AM #5
I was looking at that coupling system today, and needing to replace the original bits of plastic tube because they don't grip the threaded rod very well.
I was thinking of printing a short tube and putting two holes in the wall at each end so I could use a grub screw to lock the tube to the threaded rod and shaft.
Movement at these couplings could introduce an error in Z-axis movement.
Old Man Emu
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion