Results 1 to 10 of 107
Threaded View
-
04-04-2016, 04:42 AM #10
Hey there. Yep I have some in stock.
I do recommend the smaller PTFE tubing. It is more flexible and it allows you to load a new roll of filament without pausing since you can just push a new filament roll right after the empty one. With the bigger tubing this is more difficult since the filaments will pass each other in the tubing. The PTFE is translucent also so you can see where the filament is in the tubing.
I don't run any PLA, but the big frog looking PLA fan setup clips into the front of the carriage just like normal.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help