Results 1 to 10 of 125
Thread: 10" Pegasus Build
Threaded View
-
03-30-2016, 12:27 PM #11
I did check the stepper drivers and the one for the extruder was set to .647v (all the stepper drivers were at this high level) and I reduced it to .391v as per the troubleshooting pdf from Makerfarm but that made no difference.
Your enclosure is pretty damn cool... is that plexiglass?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion