Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 125

Threaded View

  1. 03-30-2016, 11:33 AM #10
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Quote Originally Posted by flatty_420 View Post
    ...the problem moved to the Y axis while the extruder motor extruded properly.
    what electronics does this have? Can you swap around the motor drivers or are they fixed? EDIT: review of earlier pictures suggests you should be able to swap around the motor driver boards to see if the problem is the driver board.

    You're not trying to spin the motor too fast, are you? Are you commanding the move from the LCD, or from host software?
    Last edited by printbus; 03-30-2016 at 11:49 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules