Results 1 to 10 of 125
Thread: 10" Pegasus Build
Threaded View
-
03-28-2016, 07:19 AM #10
- Join Date
- Jan 2016
- Posts
- 34
Flatty, I hope you did not drill out the Z-rod traps to much, to much play will cause backlash issues.
Also be careful of over screwing/tightening the rods into the tubing, I actually had issues with banding because I ran one in to far and it was not cut perfectly flat causing it to move slightly to one side, causing z-banding. Once I backed it off a quarter turn it was perfect.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help