Results 1 to 10 of 96
Thread: Anyone used Printbite surface ?
Threaded View
-
03-24-2016, 07:27 AM #11
well it's interesting.
so far the 3dfilaments.ie has been the best.
Got a fully working pinboard with some dirt cheap white pla.
Then tried to replicate with more expensive polymaker polyplus.
Lots of stirnging and pins welded into holes - think I need to read the printing temps again for that.
I'll probably try the polyflex next, that usually prints on a cold bed. Then the polycarbonate. And maybe, for a laugh, some abs.
Love to know how it works - the fact that at 29c it just lets go, is fascinating.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion