Results 641 to 650 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
03-21-2016, 02:36 PM #641
-
03-21-2016, 03:01 PM #642
Ya, I will know here in a week or so if it will fit. However I am redesigning a few other aspects beyond the FF upgrade.
-
03-21-2016, 05:18 PM #643
- Join Date
- Feb 2016
- Posts
- 96
-
03-21-2016, 05:20 PM #644
- Join Date
- Feb 2016
- Posts
- 96
@Kludge - are you still using the corner brackets from that Makersome kit or did you print new ones?
-
03-21-2016, 05:57 PM #645
I was using 1 from the kit and I printed two of another design from Thingiverse. I found that the glass was shifting a little so I started holding it from 3 corners which helped. I was going to try this one next:
http://www.thingiverse.com/thing:1296854
Then I dropped and shattered my glass, so now I'm temporarily printing on PET tape on top of the blue sticker that came with the Qidi. The PET tape is actually doing pretty good. It smells better than printing with the hairspray. I ordered a Maghold plate and I plan to use PET tape on top of the spring steel. Guess I'm clumsy and I don't want to break another $20 piece of glass. I have a Maghold at work on a Makerbot which has the BuildTak sticker on the spring steel. I'm learning to hate the BuildTak print surface, it just doesn't work very well compared to the hairspray or the PET tape. I really like the Maghold concept.
-
03-21-2016, 07:16 PM #646
- Join Date
- Feb 2016
- Posts
- 360
I think I attached the start of my wire chain to low in the machine, 13 links is not nearly enough...OOOPS lol.
Oh well, gonna print 4 more and it will be good to go. Well, will print them soon as my machine up and running again. Got my parts today so did alot other than install the chain.
Def interested in the 10 or 12mm upgrade to the z axis bars being spoken of.
-
03-21-2016, 08:03 PM #647
-
03-22-2016, 01:08 AM #648
- Join Date
- Feb 2016
- Posts
- 57
Any idea why this thing plays music a couple times in the middle of my print? I know I remember someone somewhere in this massive thread mention something about it being where he had temperature changes, but my print has no temperature changes.
-
03-22-2016, 08:29 AM #649
- Join Date
- Feb 2016
- Posts
- 360
-
03-22-2016, 08:49 AM #650
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion