Results 1 to 10 of 12
Thread: Question about Quality of Prints
Threaded View
-
03-20-2016, 11:34 AM #10
- Join Date
- Mar 2016
- Posts
- 68
Just a question on the 'sealed shell and cure later' suggestion... For that to work, you need a closed bottom and top, so the resin actually gets trapped, and no salt water can come in to displace the resin...
In the Cura settings thread (http://peachyprinter.ipbhost.com/ind...-printer-cura/) it says to print without a bottom, and then proceeds to suggest tilting the model, so the bottom gets printed...
I assume that for the sealed shell suggestion, you *would* want to print the bottom (and I am aware that would require a sufficiently slow drip that it actually can print that entire bottom...), correct?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion