Results 1 to 10 of 22
Thread: Strings between parts.
Threaded View
-
03-04-2014, 05:44 PM #15
It is a difficult part to print, the first one was the blue one, not bad, then the purple, don't know what happened there, last one is red and the best one I find.
I used all the same settings for all 3 except for the temperature because they are all from different manufacturer and melt at different temperatures, I found those by trial and error. I've included my settings.
IMG_20140304_183148.jpg
IMG_20140304_183158.jpg
IMG_20140304_183209.jpg
IMG_20140304_183220.jpg
image001.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion