Results 1 to 9 of 9
Thread: A couple of newbie questions
Threaded View
-
03-09-2016, 02:46 AM #8
- Join Date
- Oct 2013
- Posts
- 219
Here is the PIC of my vase. You are right..... I think the drip calibration is not correct...... so I am sure it is just a calibration issue.peachy.jpg
The marks in the base of the vase are where it was attached to the base grid.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion