Results 1 to 5 of 5
Thread: AutoHome vs ABL Z axis Height
Threaded View
-
03-06-2016, 06:14 PM #1
AutoHome vs ABL Z axis Height
Hi, Using the beckdac / Marlin code, if I do an AutoHome and then move the Z axis to zero the nozzle is 4.1mm above the glass. If I then do an ABL and move the Z axis to zero the nozzle is exactly where it should be.
I am assuming (probably a mistake) that the configuration.h value Z_PROBE_OFFSET_FROM_EXTRUDER is used for both ABL and AutoHome? Is there another value that would affect AutoHome but not ABL that could cause this discrepancy?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help