Results 1 to 10 of 17
Thread: HICTOP PRUSA i3
Threaded View
-
02-28-2016, 03:01 PM #5
- Join Date
- Feb 2016
- Posts
- 1
I cannot figure out which flavor of controller board my red mpx.3 is either.
Tom's Guide has a tutorial about how one can set up a proximity sensor for use with an aluminum heat bed, but I'm hesitant to flash my firmware with the required changes without knowing specifically what board I have.
Is this similar to yours @GATJ ?
20160228_125141.jpg
I'm having good luck with the printer as well, btw.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion