Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Hybrid View

  1. 02-28-2016, 12:53 PM #1
    kd7eir
    kd7eir is offline
    Technologist
    Join Date
    Oct 2014
    Posts
    134
    Quote Originally Posted by Chadd View Post
    Looks like either your nozzle is too close to the bed or you have some over extrusion on your first layer. Could also be a bit too hot extrusion temp.
    I have a .4 Hexagon hot end with layer height set to .23 and my nozzle set to .10mm from the bed. Does any of that look wrong?
    Reply With Quote Reply With Quote
  2. 02-28-2016, 05:42 PM #2
    Chadd
    Chadd is offline
    Engineer-in-Training
    Join Date
    Feb 2015
    Posts
    211
    Quote Originally Posted by kd7eir View Post
    I have a .4 Hexagon hot end with layer height set to .23 and my nozzle set to .10mm from the bed. Does any of that look wrong?
    Probably one of the easiest things to try would be to change your Z offset to raise your nozzle a little bit, you can always just change the offset back to what it was if it doesn't help.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules