Results 31 to 34 of 34
-
01-29-2016, 09:08 AM #31
- Join Date
- Dec 2015
- Posts
- 50
Well im definetly looking forward to installing the SSR. If my heated bed came preinstalled with the mechanical relay, do you think I can just jumper it so that it is always in the closed state thus bypassing it? And then add in a SSR and hooking it up to the RAMPS board and heated bed. I've looked at the circuit diagrams for it. Seems pretty simple.
-
01-29-2016, 11:26 AM #32
- Join Date
- Feb 2015
- Posts
- 211
-
02-19-2016, 03:13 PM #33
- Join Date
- Dec 2015
- Posts
- 50
Well it's been a little while but I finally got the relay and installed it. The prints are a thousand times better. Also got a PEI sheet while I was at it and I'm now printing ABS wonderfully too. Thanks for the help everyone!
-
02-28-2016, 12:37 PM #34
- Join Date
- Feb 2015
- Posts
- 211
Sharing our B2B 3D printing...
06-18-2024, 03:40 PM in Free Self Promotion