Results 1 to 3 of 3
Thread: Hotend Overflowing
Threaded View
-
02-27-2016, 07:38 AM #2
The threaded guide-tube in top of block (throat) must be seated tightly to the top of nozzle, inside block.
If nozzle is in all the way, then the set-screw holding tube must be loosened to allow tightening tube in further.
(the threaded end of nozzle or end of guide-tube could be deformed someway also, allowing it to leak)
Some nozzles have longer threads than others.
Replacing them with Short threaded ones may not seat to tube properly.
So tube must be moved when using the shorter nozzles.
Note: Changing that will require Re-setting the 'nozzle to bed' height adjustmentLast edited by EagleSeven; 02-29-2016 at 08:35 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion