Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 95

Thread: 12" I3V Build

Threaded View

  1. 02-25-2016, 11:23 AM #11
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    The 11A input will also need 12V going to it in order for the heat bed output to have any voltage to drive the SSR. You won't need much current. It's fine to run some light gauge jumpers from the other 12V input over to the 11A input.

    EDIT: The power input for the heat bed is kept separate in order to support those people who run a different voltage heat bed, like 24V.
    Last edited by printbus; 02-25-2016 at 12:01 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules