Results 1 to 10 of 17
Thread: a FFCP new owner here!!
Threaded View
-
02-24-2016, 05:26 AM #13
filament holder and clip are fine. Still using originals after 2 years never had a problem.
Best add on and the first thing you should print is the ducted fan adaptor to blow air on the prints.
http://www.thingiverse.com/thing:537918
I currently use the mk1 with a simple clip for easy attaching and removing. http://www.thingiverse.com/thing:350649
You'll need 24 volt 40mm fan - cheap from amazon.
I wired mine into the same connector the motherboard fan uses.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)