Results 1 to 10 of 17
Thread: a FFCP new owner here!!
Threaded View
-
02-23-2016, 07:37 PM #3
- Join Date
- Feb 2015
- Posts
- 91
Once you've gotten close on the nozzle height, the best way to get them level is to use a shim. Some people use tin foil between the cooling block and the carriage. I use a bit of a silicone kitchen mat that I cut up. Then it is an easy matter to adjust the last few hundredths of a millimeter by choosing how tight the left and right screws should be relative to each other.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion