Hello Artisan. I'm new here too with FFCP and until now I had some good and bad prints, my colleague did a lot of hours of calibrating. Prints are ok, a little stringing, but I guess with more tests it will probably go away.

The only major problem I had was the difference in height for the extruder heads. One of them was below the other one and had to print with only one head. I sent it back and received it with the problem almost fixed. The heads are still not on the same level and have problems.

I am waiting for a response in another thread http://3dprintboard.com/showthread.p...s-prints/page9 and hope to get a answer.

There are a lot of resources for the FFCP, especially here:
http://3dprintboard.com/showthread.php?491-Flashforge-3D-Creator-forum


Have fun printing and don't lose your patience.