Results 1 to 6 of 6
Threaded View
-
02-19-2016, 08:51 AM #4
- Join Date
- May 2015
- Posts
- 49
Thank you both. I see it on the schematic and found it on my board. Needs to have 2 pins soldered on, but does what I'm looking for. The next time I have the board off, I'll add them and change over to it.
Related question: If I add a cap across D9, what's a reasonable value for it? I'm concerned (probably more like superstitious) about adding caps right across a power transistor. When the cap is discharged and the MOSFET switches on the first time, doesn't the cap appear as almost a dead short initially (milliseconds)? Or am I worried about nothing?
Thanks.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion