Quote Originally Posted by rcleav View Post
My understanding is that you shouldn't consistently go over 235c with a PTFE tube. They will deform over time. With this upgrade you should be safe with 260c. Remember you still have a plastic carriage that heat creep could start to melt over time. If your comfortable with disassembling and reassembling small precise parts it should be no problem.
Also Microswiss has you do a little filing on the cold block holes I didn't do that it's very easy to mess it up.
Had to get a new cold block from Qidi Tech after I messed the first one up. Cold block was surprisingly cheap.
I have two cold blocks lol (The one that came with it, and the one that they sent with the new extruder assembly.) And it seems that BOTH have the two holes slightly off. They aren't perfectly parallel to each other, just a small thing, but makes leveling the two nozzles perfectly very hard if not impossible.