Now, here I had an issue. I tried to print this model:
http://www.thingiverse.com/thing:968669
I used Cura, 80% infill, 35mm speed, 195 deg.C, support and everything.... 0.2mm/layer.

And it came out terrible.
The red circle is around "support"... I guess it was ok. But the "green circle" is just sad... that was the lower side where the support was made. It came out very uneven and looks shit... The blue circles are some other places where the finish is pretty sad. And I am not sure what I did wrong...
Any good thoughts?
bad.jpg