all built prusa i3... still need help. :(

[klack]

ok so after some trouble shooting Colin has been helping me with... i switched the x and y drivers.. and then the skipping switched to the x axis... then i switch the now X driver with the Z axis and im no longer having the skipping issue im printing the full cube right now and it seems to be doing pretty well... ill post a pic of it as son as it is done. Though my extruder keeps getting stuck, the gear stops moving and i need to give it a little nudge every once in a while. hopefully i can get this all sorted out soon! seems like its getting there. thanks for the help guys!

[DrLuigi]

ok so after some trouble shooting Colin has been helping me with... i switched the x and y drivers.. and then the skipping switched to the x axis... then i switch the now X driver with the Z axis and im no longer having the skipping issue im printing the full cube right now and it seems to be doing pretty well... ill post a pic of it as son as it is done. Though my extruder keeps getting stuck, the gear stops moving and i need to give it a little nudge every once in a while. hopefully i can get this all sorted out soon! seems like its getting there. thanks for the help guys!

Like i already told you, its probably one of the POTs thats giving to low voltage,

Use a multimeter and a screwdriver to adjust it, and get it around 0.389-0.4 (It should be 0.39)

Just do that for all the drivers, as thats the most healthy for your motors