Results 1 to 10 of 13
Thread: Debating on getting a 3D printer
Threaded View
-
02-15-2016, 01:47 PM #10Good to know! I was getting worried reading reviews on amazon of people's nightmare stories claiming the printer they purchased was a piece of junk. I'll just have to be diligent and make sure I read up on everything.
If you're prepared to listen - we're prepared to help :-)
As long as you buy something fairly well built there's very little to go wrong.
According to guru Geoff, stepper motors are pretty much going to outlast you - let alone the machine. The electronics are well established and if you get simplify3d then the software is top notch :-)
Any issues, someone round here should be able to help.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help