Results 1 to 7 of 7
Threaded View
-
02-15-2016, 11:39 AM #2
- Join Date
- Nov 2014
- Location
- New Orleans
- Posts
- 50
Which slicing software are you using? slic3r sets a G90 command at the beginning of a print to use absolute coordinates. Your G91 command set at the end of the G-code can remedy this as you have noted.
edit:
I have noticed that after completing a print and homing X/Y, it appears that when a new print begins without resetting the printer, the motors try to home even further (from the home position) resulting in a lot of skipped steps or mechanical crashes. Therefore as Mjolinor mentions below this is definitely not the recommended solution.Last edited by dustmann; 02-15-2016 at 03:09 PM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help