Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7
  1. 02-12-2016, 01:51 PM #1
    protoquick3d
    protoquick3d is offline
    Student
    Join Date
    Feb 2016
    Posts
    5

    Marlin RC SD problem

    Hi

    I just designed and printed a new piece to raise my Z axis to 11 inches on the i3 I have. I cannot get Marlin configured for the SD card reader. I something wrong? I have Marlin working in the old 2560 but it's set for the old 200mm height. Never had a problem compiling and running the old Marlin.

    Thanks
    Reply With Quote Reply With Quote
  2. 02-12-2016, 02:21 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,183
    In the newer Marlin's the SD Card stuff has been broken out and is separate from the controller board. Are you sure you have the SD card turned on?
    Reply With Quote Reply With Quote
  3. 02-12-2016, 03:12 PM #3
    protoquick3d
    protoquick3d is offline
    Student
    Join Date
    Feb 2016
    Posts
    5
    I have the Full Graphic LCD. It always worked with the version I was using two years ago.
    Reply With Quote Reply With Quote
  4. 02-12-2016, 03:17 PM #4
    protoquick3d
    protoquick3d is offline
    Student
    Join Date
    Feb 2016
    Posts
    5
    How do I get the cool Marlin splash screen into the code? Thank you
    Reply With Quote Reply With Quote
  5. 02-12-2016, 03:41 PM #5
    protoquick3d
    protoquick3d is offline
    Student
    Join Date
    Feb 2016
    Posts
    5
    Found the SD card comment. It is now uncommented. I was starting to think I had gone stupid.
    Reply With Quote Reply With Quote
  6. 02-12-2016, 04:51 PM #6
    protoquick3d
    protoquick3d is offline
    Student
    Join Date
    Feb 2016
    Posts
    5
    Goes into hit endstop without moving. Uncommented the manual endstop. Inverted the switch logic and everything works. Really work good with the Simplify software. Thanks for your help.
    Last edited by protoquick3d; 02-13-2016 at 10:52 AM.
    Reply With Quote Reply With Quote
  7. 08-01-2016, 01:34 PM #7
    hellfire
    hellfire is offline
    Student
    Join Date
    Jul 2016
    Posts
    1
    on my controller the sd card doesn't work either.
    with my ramps i have the following problem --- when i want to move the X it works but when i want to move the Y the Y doesn't work but instead the X turns .... does anybody know how this is possible ?
    thx

    Moderator note: Post is late to appear due to unexpected delay in obtaining moderator approval
    Last edited by printbus; 10-05-2016 at 06:59 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules