Results 1 to 10 of 17
Threaded View
-
02-10-2016, 01:09 AM #16
3dsystems.com
Be aware, with this software the default print bed heat is set too high. Make sure u lower the heat. Check the previous remarks in this thread.
Also, if there is a slot you can load the gcode directly to your printer and not from your PC then try that. Come to think of it my printer acted kinda like yours when I tried to print from my USB cable connected to my computer.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion