Ah yes it seems like it'd be a little difficult to take a reading of the nozzle accurately..
I do have some temperature probes.. but not sure about sticking them in a nozzle! Although for a bed reading, I guess they'd work well..


What is the rubber legs/mat for? Just for stability? I've not noticed any vibrations as such.. but I have some rubber sheet actually which I could put under it..


I've just checked out this video.. https://www.youtube.com/watch?v=GHnbkRm9IGg and am amazed that software can make that much difference.. Perhaps if each software was taylored and tweaked, each could do the same? However, it's making me consider getting simplify3d...


I've not taken the plunge yet to ABS.. I hear changing can be tricky with regards to clearing nozzle..
Also, I'm wondering if I should use some perspex or somethingto close up the printer so the temperature is better for ABS...