Results 1 to 10 of 38
Thread: Maximum Overhang?
Threaded View
-
02-03-2016, 06:28 AM #7
- Join Date
- Oct 2013
- Posts
- 110
You probably can't print a "perfect" 90 degree overhang simply because of the mechanics of the Peachy printer - the water level is rising continuously (the printer has no control over that) and it's going to take time to print a large, flat plane. As a result, whichever bits get printed last will be higher. For accuracy, I suspect the goal will be to print a lot of layers, with minimal time spent on each one - so that the height change during each layer is kept as small as possible.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion