New to NYLON - Help? - FF CreatorPro

[curious aardvark]

You'll get better layer adhesion if you reduce you're layer height to 0.2.

why ?
layer adhesion is almost exclusively a product of the printing temperature.

You could argue that larger layer sizes are better for layer adhesion as there are fewer layers to split.
But realistically it's almost entirely down to printing temperature.
I find that for pla, 210 seems to be the sweet spot. Hot enough to give a really good meld and cool enough to still get clean and sharp prints.

@josh
lol you're welcome. I'll pass on the kiss, wouldn't want to give you beard rash ;-)
You might also check out 3dfilaprint as well - the other side of globalfsd, they sell the full reels. Best prices in the uk that I've found - mainly because all their prices include p&p :-)
And the only ones who sell reppapper tech - my current favourite filament manufacturer, though polymaker run them a close second.
And they're a good bunch as well, always load me up with free stuff at the tct show :-)
Mind you so did polymaker.

Where abouts are you in the uk ?