Results 1 to 10 of 13
Thread: CTC printer settings
Threaded View
-
02-02-2016, 11:12 AM #11
If I remember correctly there is a Firmware setting to select which nozzle is #0 and which is #1.
(new firmware may have the nozzles Reversed ? )
So, maybe if you switch those it will fix the startup location and keep them over bed-plate ?
Then select the correct nozzle in slicer software as primary (#0) and secondary (#1),
to select which to use when printing.Last edited by EagleSeven; 02-02-2016 at 11:41 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help