Results 1 to 10 of 18
Threaded View
-
01-28-2016, 10:39 AM #3
- Join Date
- Nov 2014
- Location
- Brevard, NC
- Posts
- 182
Prints came out pretty good for the 1st version, but was off by 1.5mm in centering the motor shaft hole. Now that I have the parts to play with, I can see a better way to do the bracing in the back. I could probably file that 1.5mm down, but may as well redesign this a better way before taking my printer apart to replace this. Everything seems to line nicely except for the motor hole. The Right side took 8.25 hours to print & weighs 3.5oz at 50% fill. Here are some photos of the 1st printing.
IMG_9709_800x600.jpgIMG_9711_800x600.jpgIMG_9714_800x600.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion