Thanks all for the quick responses.

I am going to talk a look again at rotating it. At first the angle looked greater than 45° so I thought it would be ok.

I haven't used PVA yet. Still fairly new.

I did use 3 shells. Don't know why I wrote 2. As for the infill, I was following the designers suggestions.

http://www.vicious1.com/blog/parts/

I do have active cooling (one of the first things I ever printed) and had it on for all but one. http://www.thingiverse.com/thing:537918

I usually print almost everything at .2 but his suggestion was .26

I will need to look at the speed settings when I get home. But I will slow it down. Still a little hesitant on changing the settings and what they do. Still learning.

Overall, I believe the part is still usable. I'll find out once I put it all together.

Thanks everyone for all the suggestions.