Results 1 to 1 of 1
Thread: SD / speed problem
-
01-24-2016, 10:13 AM #1
- Join Date
- Jan 2016
- Posts
- 1
SD / speed problem
Hi everyone!
I am new to 3d printers. I just got my "refurbished" Flash Forge Creator Pro in the mail and have happily done about half a dozen 6 hr prints over USB.
Now I am trying to use the SD card and haven't had a successful print yet (even when running the same job that I did over USB). It seems like the feedrates are noticeably faster when running off the sd card. I think this excessive speed is then causing skipping midway through the print that leads to a slanted finished product.
Any thoughts?
I am printing ABS and have my feedrates set to 60 and 80.
Thanks,
Matt
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help