Results 1 to 5 of 5
Thread: S3d platform purge line
-
01-17-2016, 12:00 PM #1
- Join Date
- Dec 2015
- Posts
- 7
S3d platform purge line
For the short time I used RepG the one thing I liked and I think helped out tremendously is the start. RepG prints a full line across the front edge of the platform then proceeds to the object. With S3d right now the problem that I have is roughly the first 5/6 seconds do not stick to the bed and fail but if i don't cancel the print the filament grabs and proceeds without issue.
Any knowledge or script somewhere I can grab to make it replicate the RepG start ?
I'm using glass bed with abs juice
-
01-17-2016, 03:43 PM #2
Better off just doing a skirt around the object.
-
01-17-2016, 04:54 PM #3
- Join Date
- Oct 2014
- Posts
- 93
i have just purchased s3d, and i still have the purge line, but i also have a skirt set, and works very very well
-
01-17-2016, 05:27 PM #4
- Join Date
- Dec 2015
- Posts
- 7
Ah very good call with the skirt don't know why I didn't think about that thanks !
-
01-18-2016, 09:47 AM #5
The latest version of S3D does that line across the front edge by default. However, I also use a skirt, and if I'm printing with both extruders I use either an ooze shield or a prime pillar, depending on how large the print is.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help