Rough first layer

[AmbientG]

I started with it at 90% height but the corners lifted so I lowered it instead of getting the nozzle even closer since it was very tight against the paper already. I will change it back to see if it makes a difference.

My speed is usually at 80-100mm/s and first layer is at 30%.

As for the second layer, it gets better and then even better by the 3rd/4th solid layer. I also do get a few over extruded dots on the side walls and on the top surface that I haven't been able to clean up yet. Not a deal breaker but not perfectly dialed in yet.