Results 151 to 160 of 189
Thread: Show your MODS
Threaded View
-
01-15-2016, 12:18 AM #11
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I, too, am designing an enclosure for my printer, as it's getting relocated to the basement. I don't have any materials yet, just the plans. It'll be made out of 3/4 inch plywood, all the electronics mounted on the outside, with a RaspberryPi for printer control, camera and web access.printerbox4.jpgprinterbox2.jpg
The printer will be mounted to a square of plywood which can slide in and out of the box for maintenance. Lights and a webcam will be on the inside so prints can be monitored without needing to open the box. Internal dimensions will be 2ft cubed, plus a little extra in the Z to accommodate the printer shelf. I intend to have some flexible tubing connecting to the rear of the box and to the hotend fan to prevent overheat jams.
Cura slicer issue
09-13-2024, 02:44 AM in 3D Printing Slicer Discussion