Results 1 to 4 of 4
Thread: Problem with the "first Layer"
-
01-07-2016, 02:12 PM #1
- Join Date
- Nov 2015
- Posts
- 6
Problem with the "first Layer"
Hi Guys its me again,
i have a problem with the first outpush of the filament when the print starts... It is way to close on the bed and dont want to push smth out. Its get stuck on the side and pushes the printing away from the bed... Which setting is this on Cura ?!I tried bedZoffset but it didnt work..
thanks for the help !
-
01-07-2016, 04:14 PM #2
-
01-07-2016, 04:45 PM #3
- Join Date
- Nov 2015
- Posts
- 6
I did this 4 times but didnt work... Oh and i have a similar problem like on of our members here. My printbed just "bended" and isnt leveled anymore. Its crooked. What causes this ?!
-
01-07-2016, 04:56 PM #4
I suggest that you add a Glass plate to the bed.
That gives you a flatter, smoother surface and makes it easier to adjust.
(remove all tape and sand aluminum-plate before applying hair-spray
to attach glass to aluminum)
(3/32" is good thickness for glass)
(clamp glass to bed until spray dries)
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help