Results 1 to 8 of 8
Thread: Printing tiny things
Threaded View
-
01-06-2016, 07:11 AM #5
There are a series of analysis and explanations on the hydraraptor blog : he investigated that in 2011. Some of the parameters can't be corrected as they are process induced (arc shrinkage) and others are not practical to correct (the cosPi/n correction) so the bottom line (for me !) was to set the diameter I wanted and re-drill after because the general conclusion is that the printed hole will always be smaller than the intended cylinder.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion