Results 1 to 10 of 10
Thread: Hot end and stepper motor issue.
Threaded View
-
01-06-2016, 12:01 AM #3
- Join Date
- Dec 2015
- Posts
- 50
I just compared the voltage on the stepper drivers with the hot end off and with it heating and when it's off they are at 0.66 mV but when it's heating the voltage increases to 0.8 mV. Is 0.8 too high? I heard 0.66 might even be too high but I don't know.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion