Results 1 to 10 of 23
Thread: Dip the Print - surface tension
Threaded View
-
02-27-2014, 08:40 AM #4
- Join Date
- Oct 2013
- Posts
- 219
The print would be glued to the moveable platform ........... I need to sketch it............ but it would certainly work. I don't think I am explaining this very well, the print is started on the tilting platform i.e. glued to it or a wire insert on the platform. Thus tilting the platform, dips the print beneath the surface of the resin by 2-3 mm. The tilt rod runs up the side of the tank and is operated by a spring loaded solenoid. Laser OFF, turns power off to the solenoid, allowing the spring to release and push the rod to tilt the platform. Laser ON, repowers the solenoid and re-compresses the spring, pulling the rod back.
Last edited by mike_biddell; 02-27-2014 at 08:48 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help