Results 1 to 8 of 8
Thread: Circular hole coming out oval
Threaded View
-
01-03-2016, 12:01 PM #8
- Join Date
- Dec 2015
- Posts
- 80
On glass with glue spread on it.
I think the glue isnt good enough if it really is a sticking issue. Will be trying abs juice tomorrow.
edit
90% SOLVED: I was looking at the wrong Y belts. I found that the short belt connected to the Y motor on the back right of the printer, which actually drives the Y axles, was loose.
Loosening the motor and them pushing it further down and re-tightening the screws, tightened the belt and now the circles are a lot better, though still not perfectly circular.
Before
20151226_195909b.jpg
After
20160103_223810.jpgLast edited by bigo93; 01-19-2016 at 07:42 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion